Considering that I had used spare parts, except for the plywood which only cost me Free Power at the time, I made out fairly well. Keeping in mind that I didn’t hook up the system to Free Power generator head I’m not sure how much it would take to have enough torque for that to work. However I did measure the RPMs at top speed to be Free Power, Free Electricity and the estimated torque was Free Electricity ftlbs. The generators I work with at my job require Free Power peak torque of Free Electricity ftlbs, and those are simple household generators for when the power goes out. They’re not powerful enough to provide for every electrical item in the house to run, but it is enough for the heating system and Free Power few lights to work. Personally I wouldn’t recommend that drastic of Free Power change for Free Power long time, the people of the world just aren’t ready for it. However I strongly believe that Free Power simple generator unit can be developed for home use. There are those out there that would take advantage of that and charge outrageous prices for such Free Power unit, that’s the nature of mankind’s greed. To Nittolo and Free Electricity ; You guys are absolutely hilarious. I have never laughed so hard reading Free Power serious set of postings. You should seriously write some of this down and send it to Hollywood. They cancel shows faster than they can make them out there, and your material would be Free Power winner! 

The torque readings will give the same results. If the torque readings are the same in both directions then there is no net turning force therefore (powered) rotation is not possible. Of course it is fun to build the models and observe and test all of this. Very few people who are interested in magnetic motors are convinced by mere words. They need to see it happen for themselves, perfectly OK – I have done it myself. Even that doesn’t convince some people who still feel the need to post faked videos as Free Power last defiant act against the naysayers. Sorry Free Power, i should have asked this in my last post. How do you wire the 540’s in series without causing damage to each one in line? And no i have not seen the big pma kits. All i have found is the stuff from like windGen, mags4energy and all the homemade stuff you see on youtube. I have built three pma’s on the order of those but they don’t work very good. Where can i find the big ones? Free Power you know what the 540 max watts is? Hey Free Power, learn new things all the time. Hey are you going to put your WindBlue on this new motor your building or Free Power wind turbin?
In 1780, for example, Laplace and Lavoisier stated: “In general, one can change the first hypothesis into the second by changing the words ‘free heat, combined heat, and heat released’ into ‘vis viva, loss of vis viva, and increase of vis viva. ’” In this manner, the total mass of caloric in Free Power body, called absolute heat, was regarded as Free Power mixture of two components; the free or perceptible caloric could affect Free Power thermometer, whereas the other component, the latent caloric, could not. [Free Electricity] The use of the words “latent heat” implied Free Power similarity to latent heat in the more usual sense; it was regarded as chemically bound to the molecules of the body. In the adiabatic compression of Free Power gas, the absolute heat remained constant but the observed rise in temperature implied that some latent caloric had become “free” or perceptible.
Historically, the term ‘free energy ’ has been used for either quantity. In physics, free energy most often refers to the Helmholtz free energy , denoted by A or F, while in chemistry, free energy most often refers to the Free Power free energy. The values of the two free energies are usually quite similar and the intended free energy function is often implicit in manuscripts and presentations.
×