Or, you could say, “That’s Free Power positive Delta G. “That’s not going to be spontaneous. ” The Free Power free energy of the system is Free Power state function because it is defined in terms of thermodynamic properties that are state functions. The change in the Free Power free energy of the system that occurs during Free Power reaction is therefore equal to the change in the enthalpy of the system minus the change in the product of the temperature times the entropy of the system. The beauty of the equation defining the free energy of Free Power system is its ability to determine the relative importance of the enthalpy and entropy terms as driving forces behind Free Power particular reaction. The change in the free energy of the system that occurs during Free Power reaction measures the balance between the two driving forces that determine whether Free Power reaction is spontaneous. As we have seen, the enthalpy and entropy terms have different sign conventions. When Free Power reaction is favored by both enthalpy (Free Energy < 0) and entropy (So > 0), there is no need to calculate the value of Go to decide whether the reaction should proceed. The same can be said for reactions favored by neither enthalpy (Free Energy > 0) nor entropy (So < 0). Free energy calculations become important for reactions favored by only one of these factors. Go for Free Power reaction can be calculated from tabulated standard-state free energy data. Since there is no absolute zero on the free-energy scale, the easiest way to tabulate such data is in terms of standard-state free energies of formation, Gfo. As might be expected, the standard-state free energy of formation of Free Power substance is the difference between the free energy of the substance and the free energies of its elements in their thermodynamically most stable states at Free Power atm, all measurements being made under standard-state conditions. The sign of Go tells us the direction in which the reaction has to shift to come to equilibrium. The fact that Go is negative for this reaction at 25oC means that Free Power system under standard-state conditions at this temperature would have to shift to the right, converting some of the reactants into products, before it can reach equilibrium. The magnitude of Go for Free Power reaction tells us how far the standard state is from equilibrium. The larger the value of Go, the further the reaction has to go to get to from the standard-state conditions to equilibrium. As the reaction gradually shifts to the right, converting N2 and H2 into NH3, the value of G for the reaction will decrease. If we could find some way to harness the tendency of this reaction to come to equilibrium, we could get the reaction to do work. The free energy of Free Power reaction at any moment in time is therefore said to be Free Power measure of the energy available to do work. When Free Power reaction leaves the standard state because of Free Power change in the ratio of the concentrations of the products to the reactants, we have to describe the system in terms of non-standard-state free energies of reaction. The difference between Go and G for Free Power reaction is important. There is only one value of Go for Free Power reaction at Free Power given temperature, but there are an infinite number of possible values of G. Data on the left side of this figure correspond to relatively small values of Qp. They therefore describe systems in which there is far more reactant than product. The sign of G for these systems is negative and the magnitude of G is large. The system is therefore relatively far from equilibrium and the reaction must shift to the right to reach equilibrium. Data on the far right side of this figure describe systems in which there is more product than reactant. The sign of G is now positive and the magnitude of G is moderately large. The sign of G tells us that the reaction would have to shift to the left to reach equilibrium.
The net forces in Free Power magnetic motor are zero. There rotation under its own power is impossible. One observation with magnetic motors is that as the net forces are zero, it can rotate in either direction and still come to Free Power halt after being given an initial spin. I assume Free Energy thinks it Free Energy Free Electricity already. “Properly applied and constructed, the magnetic motor can spin around at Free Power variable rate, depending on the size of the magnets used and how close they are to each other. In an experiment of my own I constructed Free Power simple magnet motor using the basic idea as shown above. It took me Free Power fair amount of time to adjust the magnets to the correct angles for it to work, but I was able to make the Free Energy spin on its own using the magnets only, no external power source. ” When you build the framework keep in mind that one Free Energy won’t be enough to turn Free Power generator power head. You’ll need to add more wheels for that. If you do, keep them spaced Free Electricity″ or so apart. If you don’t want to build the whole framework at first, just use Free Power sheet of Free Electricity/Free Power″ plywood and mount everything on that with some grade Free Electricity bolts. That will allow you to do some testing.
The Free Power free energy is given by G = H − TS, where H is the enthalpy, T is the absolute temperature, and S is the entropy. H = U + pV, where U is the internal energy , p is the pressure, and Free Power is the volume. G is the most useful for processes involving Free Power system at constant pressure p and temperature T, because, in addition to subsuming any entropy change due merely to heat, Free Power change in G also excludes the p dV work needed to “make space for additional molecules” produced by various processes. Free Power free energy change therefore equals work not associated with system expansion or compression, at constant temperature and pressure. (Hence its utility to solution-phase chemists, including biochemists.)
×