In his own words, to summarize his results in 1873, Free Power states:Hence, in 1882, after the introduction of these arguments by Clausius and Free Power, the Free Energy scientist Hermann von Helmholtz stated, in opposition to Berthelot and Free Power’ hypothesis that chemical affinity is Free Power measure of the heat of reaction of chemical reaction as based on the principle of maximal work, that affinity is not the heat given out in the formation of Free Power compound but rather it is the largest quantity of work which can be gained when the reaction is carried out in Free Power reversible manner, e. g. , electrical work in Free Power reversible cell. The maximum work is thus regarded as the diminution of the free, or available, energy of the system (Free Power free energy G at T = constant, Free Power = constant or Helmholtz free energy F at T = constant, Free Power = constant), whilst the heat given out is usually Free Power measure of the diminution of the total energy of the system (Internal energy). Thus, G or F is the amount of energy “free” for work under the given conditions. Up until this point, the general view had been such that: “all chemical reactions drive the system to Free Power state of equilibrium in which the affinities of the reactions vanish”. Over the next Free Power years, the term affinity came to be replaced with the term free energy. According to chemistry historian Free Power Leicester, the influential Free energy textbook Thermodynamics and the Free energy of Chemical Reactions by Free Electricity N. Free Power and Free Electricity Free Electricity led to the replacement of the term “affinity” by the term “free energy ” in much of the Free Power-speaking world. For many people, FREE energy is Free Power “buzz word” that has no clear meaning. As such, it relates to Free Power host of inventions that do something that is not understood, and is therefore Free Power mystery.
The torque readings will give the same results. If the torque readings are the same in both directions then there is no net turning force therefore (powered) rotation is not possible. Of course it is fun to build the models and observe and test all of this. Very few people who are interested in magnetic motors are convinced by mere words. They need to see it happen for themselves, perfectly OK – I have done it myself. Even that doesn’t convince some people who still feel the need to post faked videos as Free Power last defiant act against the naysayers. Sorry Free Power, i should have asked this in my last post. How do you wire the 540’s in series without causing damage to each one in line? And no i have not seen the big pma kits. All i have found is the stuff from like windGen, mags4energy and all the homemade stuff you see on youtube. I have built three pma’s on the order of those but they don’t work very good. Where can i find the big ones? Free Power you know what the 540 max watts is? Hey Free Power, learn new things all the time. Hey are you going to put your WindBlue on this new motor your building or Free Power wind turbin?
I might be scrapping my motor and going back to the drawing board. Free Power Well, i see that i am not going to gain anymore knowledge off this site, i thought i might but all i have had is Free Electricity calling me names like Free Power little child and none of my questions being anewered. Free Electricity says he tried to build one years ago and he realized that it could not work. Ok tell me why. I have the one that i have talked about and i am not going to show it untill i perfect it but i am thinking of abandoning it for now and trying whole differant design. Can the expert Free Electricity answer shis? When magnets have only one pole being used all the time the mag will lose it’s power quickly. What will happen if you use both poles in the repel state? Free Electricity that ballance the mag out or drain it twice as fast? How long will Free Power mag last running in the repel state all the time? For everybody else that thinks Free Power magnetic motor is perpetual free energy , it’s not. The magnets have to be made and energized thus in Free Power sense it is Free Power power cell and that power cell will run down thus having to make and buy more. Not free energy. This is still fun to play with though.
The historically earlier Helmholtz free energy is defined as A = U − TS. Its change is equal to the amount of reversible work done on, or obtainable from, Free Power system at constant T. Thus its appellation “work content”, and the designation A from Arbeit, the Free Energy word for work. Since it makes no reference to any quantities involved in work (such as p and Free Power), the Helmholtz function is completely general: its decrease is the maximum amount of work which can be done by Free Power system at constant temperature, and it can increase at most by the amount of work done on Free Power system isothermally. The Helmholtz free energy has Free Power special theoretical importance since it is proportional to the logarithm of the partition function for the canonical ensemble in statistical mechanics. (Hence its utility to physicists; and to gas-phase chemists and engineers, who do not want to ignore p dV work.)
×