To understand why this is the case, it’s useful to bring up the concept of chemical equilibrium. As Free Power refresher on chemical equilibrium, let’s imagine that we start Free Power reversible reaction with pure reactants (no product present at all). At first, the forward reaction will proceed rapidly, as there are lots of reactants that can be converted into products. The reverse reaction, in contrast, will not take place at all, as there are no products to turn back into reactants. As product accumulates, however, the reverse reaction will begin to happen more and more often. This process will continue until the reaction system reaches Free Power balance point, called chemical equilibrium, at which the forward and reverse reactions take place at the same rate. At this point, both reactions continue to occur, but the overall concentrations of products and reactants no longer change. Each reaction has its own unique, characteristic ratio of products to reactants at equilibrium. When Free Power reaction system is at equilibrium, it is in its lowest-energy state possible (has the least possible free energy).
Even the use of replacable magnesium plates in Free Power battery every Free energy -Free Power miles gives the necessary range for Free energy families for long trips. Magnet-only motors are easy to build. There are plans around. They are cheap to build. Trouble is no one knows how to get them to spin unaided. I have lost count of the people I have corresponded with who seriously believe that magnetising Free Power magnet somehow gives it energy that is then used to drive the motor. Once rumours about how magnetic motors “work” they spread through the free energy websites and forums as “truth”. The blindly ignorant population believe what is proclaimed because they don’t have the education or experience to be able to question the bogus Free Energy. I suppose with people wholeheartedly believing an all powerful supernatural being created the entire universe it isn’t hard for them to believe Free Power magnet can power Free Power motor. Both thoughts demonstrate ignorance. To follow up on my own comment, optimistically, if the “drag” created by the production of electricity is less than the permanent magnetic “drive” required of the rotating armature or field, theoretically it could work. Someone noted in Free Power previous posting that Telsa already developed this motor.
The historically earlier Helmholtz free energy is defined as A = U − TS. Its change is equal to the amount of reversible work done on, or obtainable from, Free Power system at constant T. Thus its appellation “work content”, and the designation A from Arbeit, the Free Energy word for work. Since it makes no reference to any quantities involved in work (such as p and Free Power), the Helmholtz function is completely general: its decrease is the maximum amount of work which can be done by Free Power system at constant temperature, and it can increase at most by the amount of work done on Free Power system isothermally. The Helmholtz free energy has Free Power special theoretical importance since it is proportional to the logarithm of the partition function for the canonical ensemble in statistical mechanics. (Hence its utility to physicists; and to gas-phase chemists and engineers, who do not want to ignore p dV work.)