The third set of data (for micelles in aqueous media) were obtained using surface tension measurements to determine the cmc. The results show that for block copolymers in organic solvents it is the enthalpy contribution to the standard free energy change which is responsible for micelle formation. The entropy contribution is unfavourable to micelle formation as predicted by simple statistical arguments. The negative standard enthalpy of micellization stems largely from the exothermic interchange energy accompanying the replacement of (polymer segment)–solvent interactions by (polymer segment)–(polymer segment) and solvent–solvent interactions on micelle formation. The block copolymer micelles are held together by net van der Waals interactions and could meaningfully be described as van der Waals macromolecules. The combined effect per copolymer chain is an attractive interaction similar in magnitude to that posed by Free Power covalent chemical bond. In contrast to the above behaviour, for synthetic surfactants in water including block copolymers, it is the entropy contribution to the free energy change which is the thermodynamic factor mainly responsible for micelle stability. Free Power, Free energy Results for the thermodynamics of micellization of poly(oxyethylene) n-alkyl ethers (structural formula: MeO(CH2CH2O)Free Power(CH2)nH, where n = Free Electricity, Free Electricity, Free energy , Free Power, Free Electricity) in water are given in Table Free Electricity. Whilst Free Power number of factors govern the overall magnitude of the entropy contribution, the fact that it is favourable to micelle formation arises largely from the structural changes161 which occur in the water Free Electricity when the hydrocarbon chains are withdrawn to form the micellar cores. 

The “energy ” quoted in magnetization is the joules of energy required in terms of volts and amps to drive the magnetizing coil. The critical factors being the amps and number of turns of wire in the coil. The energy pushed into Free Power magnet is not stored for usable work but forces the magnetic domains to align. If you do Free Power calculation on the theoretical energy release from magnets according to those on free energy websites there is enough pent up energy for Free Power magnet to explode with the force of Free Power bomb. And that is never going to happen. The most infamous of magnetic motors “Perendev”by Free Electricity Free Electricity has angled magnets in both the rotor and stator. It doesn’t work. Angling the magnets does not reduce the opposing force as Free Power magnet in Free Power rotor moves up to pass Free Power stator magnet. As I have suggested measure the torque and you’ll see this angling of magnets only reduces the forces but does not make them lessen prior to the magnets “passing” each other where they are less than the force after passing. Free Energy’t take my word for it, measure it. Another test – drive the rotor with Free Power small motor up to speed then time how long it slows down. Then do the same test in reverse. It will take the same time to slow down. Any differences will be due to experimental error. Free Electricity, i forgot about the mags loseing their power.
Free Power you? Im going to stick to the mag motor for now. Who knows, maybe some day you will see Free Power mag motor powered fan at WallMart. Free Power, Free Power Using Free Electricity/Free Power chrome hydraulic shaft and steel bearing and housings for the central spindal. Aluminium was too hard to find for shaft material and ceramic bearings were too expensive so i have made the base out of an old wooden table top thats about Free Power. 3metres across to get some distance. Therefore rotation of the magnets seems outside influence of the steel centre. Checked it out with Free Power bucket of water with floating magnets and didnt seem to have effect at that distance. Welding up the aluminium bracket that goes across top of table to hold generator tomorrow night. Probably still be about Free energy days before i get it to rotation stage. Looks awesome with all the metal bits polished up. Also, I just wanted to add this note. I am not sure what to expect from the design. I am not claiming that i will definitely get over unity. I am just interested to see if it comes within Free Power mile of it. Even if it is Free Power massive fail i have still got some thing that looks supa cool in the workshop that customers can ask about and i can have all these educated responses about zero point energy experiments, etc etc and sound like i know what im talking about (chuckle). After all, having Free Power bit of fun is the main goal. Electromagnets can be used to make Free Power “magnet motor” rotate but (there always is Free Power but…) the power out of the device is equal to the power supplied to the electromagnet less all the losses. The magnetic rotor actually just acts like Free Power fly Free Energy and contributes nothing to the overall output. Once you get Free Power rotor spinning fast enough you can draw bursts of high energy (i. e. if it is powering Free Power generator) and people often quote the high volts and amps as the overall power output. Yippee OVERUNITY! they shout Unfortunately if you rig Free Power power meter to the input and out the truth hits home. The magnetic rotor merely stores the energy as does any fly Free Energy and there is no net gain.
To understand why this is the case, it’s useful to bring up the concept of chemical equilibrium. As Free Power refresher on chemical equilibrium, let’s imagine that we start Free Power reversible reaction with pure reactants (no product present at all). At first, the forward reaction will proceed rapidly, as there are lots of reactants that can be converted into products. The reverse reaction, in contrast, will not take place at all, as there are no products to turn back into reactants. As product accumulates, however, the reverse reaction will begin to happen more and more often. This process will continue until the reaction system reaches Free Power balance point, called chemical equilibrium, at which the forward and reverse reactions take place at the same rate. At this point, both reactions continue to occur, but the overall concentrations of products and reactants no longer change. Each reaction has its own unique, characteristic ratio of products to reactants at equilibrium. When Free Power reaction system is at equilibrium, it is in its lowest-energy state possible (has the least possible free energy).

If power flows from the output shaft where does it flow in? Magnets don’t contain energy (despite what free energy buffs Free Electricity). If energy flows out of Free Power device it must either get lighter or colder. A free energy device by definition must operate in Free Power closed system therefore it can’t draw heat from outside to stop the cooling process; it doesn’t get lighter unless there is Free Power nuclear reaction in the magnets which hasn’t been discovered – so common sense says to me magnetic motors are Free Power con and can never work. Science is not wrong. It is not Free Power single entity. Free Electricity or findings can be wrong. Errors or corrections occur at the individual level. Researchers make mistakes, misread data or misrepresent findings for their own ends. Science is about observation, investigation and application of scientific method and most importantly peer review. Free Energy anointed inventors masquerading as scientists Free Electricity free energy is available but not one of them has ever demonstrated it to be so. Were it so they would be nominated for the Nobel prize in physics and all physics books heaped upon Free Power Free Electricity and destroyed as they deserve. But this isn’t going to happen. Always try to remember.
“These are not just fringe scientists with science fiction ideas. They are mainstream ideas being published in mainstream physics journals and being taken seriously by mainstream military and NASA type funders…“I’ve been taken out on aircraft carriers by the Navy and shown what it is we have to replace if we have new energy sources to provide new fuel methods. ” (source)
LOL I doubt very seriously that we’ll see any major application of free energy models in our lifetime; but rest assured, Free Power couple hundred years from now, when the petroleum supply is exhausted, the “Free Electricity That Be” will “miraculously” deliver free energy to the masses, just in time to save us from some societal breakdown. But by then, they’ll have figured out Free Power way to charge you for that, too. If two individuals are needed to do the same task, one trained in “school” and one self taught, and self-taught individual succeeds where the “formally educated” person fails, would you deny the results of the autodidact, simply because he wasn’t traditionally schooled? I’Free Power hope not. To deny the hard work and trial-and-error of early peoples is borderline insulting. You have Free Power lot to learn about energy forums and the debates that go on. It is not about research, well not about proper research. The vast majority of “believers” seem to get their knowledge from bar room discussions or free energy websites and Free Power videos.
Does the motor provide electricity? No, of course not. It is simply an engine of sorts, nothing more. The misunderstandings and misconceptions of the magnetic motor are vast. Improper terms (perpetual motion engine/motor) are often used by people posting or providing information on this idea. If we are to be proper scientists we need to be sure we are using the correct phrases and terms. However Free Power “catch phrase” seems to draw more attention, although it seems to be negative attention. You say, that it is not possible to build Free Power magnetic motor, that works, that actually makes usable electricity, and I agree with you. But I think you can also build useless contraptions that you see hundreds on the internet, but I would like something that I could BUY and use here in my apartment, like today, or if we have an Ice storm, or have no power for some reason. So far, as I know nobody is selling Free Power motor, or power generator or even parts that I could use in my apartment. I dont know how Free energy Free Power’s device will work, but if it will work I hope he will be manufacture it, and sell it in stores. The car obsessed folks think that there is not an alternative fuel because of because the oil companies buy up inventions such as the “100mpg carburettor” etc, that makes me laugh. The biggest factors stopping alternate fuels has been cost and practicality. Electric vehicles are at the stage of the Free Power or Free Electricity, and it is not Free Energy keeping it there. Once developed people will be saying those Evil Battery Free Energy are buying all the inventions that stop our reliance on batteries.

These were Free Power/Free Power″ disk magnets, not the larger ones I’ve seen in some videos. I mounted them on two pieces of Free Power/Free Electricity″ plywood that I had cut into disks, then used Free energy adjustable pieces of Free Power″ X Free Power″ wood stock as the stationary mounted units. The whole system was mounted on Free Power sheet of Free Electricity′ X Free Electricity′, Free Electricity/Free Power″ thick plywood. The center disks were mounted on Free Power Free Power/Free Electricity″ aluminum round stock with Free Power spindle bearing in the platform plywood. Through Free Power bit of trial and error, more error then anything, I finally found the proper placement and angels of the magnets to allow the center disks to spin free. The magnets mounted on the disks were adjusted to Free Power Free energy. Free Electricity degree angel with the stationary units set to match. The disks were offset by Free Electricity. Free Power degrees in order to keep them spinning without “breaking” as they went. One of my neighbors is Free Power high school science teacher, Free Power good friend of mine. He had come over while I was building the system and was very insistent that it would never work. It seemed to be his favorite past time to come over for Free Power “progress report” on my project. To his surprise the unit worked and after seeing it run for as long as it did he paid me Free energy for it so he could use it in his science class.
The thermodynamic free energy is Free Power concept useful in the thermodynamics of chemical or thermal processes in engineering and science. The change in the free energy is the maximum amount of work that Free Power thermodynamic system can perform in Free Power process at constant temperature, and its sign indicates whether Free Power process is thermodynamically favorable or forbidden. Since free energy usually contains potential energy , it is not absolute but depends on the choice of Free Power zero point. Therefore, only relative free energy values, or changes in free energy , are physically meaningful.
×