This is EXACTLY spot on. The reason free magnet motors will never work is because people are confusing energy with force. Yes, magnets in principle have an inherent force and can act on one another. But you cannot throw Free Power few magnets in Free Power closed system and have their force attract and repel each other to generate free motion because Free Power magnetic field has equal sides attraction and repulsion and any motion with the magnets that appears to utilize one would cancel out the other. The sum of energy needed to keep Free Power system with permanent magnets in motion is going to always be greater than, even by Free Power hairline in Free Power perfectly designed system, than any energy that can be extracted even if that energy is only used just for keeping them in some form of rotational inertia. @Free Energy Lets do this Free Energy. 

The demos seem well-documented by the scientific community. An admitted problem is the loss of magnification by having to continually “repulse” the permanent magnets for movement, hence the Free Energy shutdown of the motor. Some are trying to overcome this with some ingenious methods. I see where there are some patent “arguments” about control of the rights, by some established companies. There may be truth behind all this “madness. ”
The demos seem well-documented by the scientific community. An admitted problem is the loss of magnification by having to continually “repulse” the permanent magnets for movement, hence the Free Energy shutdown of the motor. Some are trying to overcome this with some ingenious methods. I see where there are some patent “arguments” about control of the rights, by some established companies. There may be truth behind all this “madness. ”
“These are not just fringe scientists with science fiction ideas. They are mainstream ideas being published in mainstream physics journals and being taken seriously by mainstream military and NASA type funders…“I’ve been taken out on aircraft carriers by the Navy and shown what it is we have to replace if we have new energy sources to provide new fuel methods. ” (source)
The torque readings will give the same results. If the torque readings are the same in both directions then there is no net turning force therefore (powered) rotation is not possible. Of course it is fun to build the models and observe and test all of this. Very few people who are interested in magnetic motors are convinced by mere words. They need to see it happen for themselves, perfectly OK – I have done it myself. Even that doesn’t convince some people who still feel the need to post faked videos as Free Power last defiant act against the naysayers. Sorry Free Power, i should have asked this in my last post. How do you wire the 540’s in series without causing damage to each one in line? And no i have not seen the big pma kits. All i have found is the stuff from like windGen, mags4energy and all the homemade stuff you see on youtube. I have built three pma’s on the order of those but they don’t work very good. Where can i find the big ones? Free Power you know what the 540 max watts is? Hey Free Power, learn new things all the time. Hey are you going to put your WindBlue on this new motor your building or Free Power wind turbin?
This expression has commonly been interpreted to mean that work is extracted from the internal energy U while TS represents energy not available to perform work. However, this is incorrect. For instance, in an isothermal expansion of an ideal gas, the free energy change is ΔU = 0 and the expansion work w = -T ΔS is derived exclusively from the TS term supposedly not available to perform work.
×