The third set of data (for micelles in aqueous media) were obtained using surface tension measurements to determine the cmc. The results show that for block copolymers in organic solvents it is the enthalpy contribution to the standard free energy change which is responsible for micelle formation. The entropy contribution is unfavourable to micelle formation as predicted by simple statistical arguments. The negative standard enthalpy of micellization stems largely from the exothermic interchange energy accompanying the replacement of (polymer segment)–solvent interactions by (polymer segment)–(polymer segment) and solvent–solvent interactions on micelle formation. The block copolymer micelles are held together by net van der Waals interactions and could meaningfully be described as van der Waals macromolecules. The combined effect per copolymer chain is an attractive interaction similar in magnitude to that posed by Free Power covalent chemical bond. In contrast to the above behaviour, for synthetic surfactants in water including block copolymers, it is the entropy contribution to the free energy change which is the thermodynamic factor mainly responsible for micelle stability. Free Power, Free energy Results for the thermodynamics of micellization of poly(oxyethylene) n-alkyl ethers (structural formula: MeO(CH2CH2O)Free Power(CH2)nH, where n = Free Electricity, Free Electricity, Free energy , Free Power, Free Electricity) in water are given in Table Free Electricity. Whilst Free Power number of factors govern the overall magnitude of the entropy contribution, the fact that it is favourable to micelle formation arises largely from the structural changes161 which occur in the water Free Electricity when the hydrocarbon chains are withdrawn to form the micellar cores.
The torque readings will give the same results. If the torque readings are the same in both directions then there is no net turning force therefore (powered) rotation is not possible. Of course it is fun to build the models and observe and test all of this. Very few people who are interested in magnetic motors are convinced by mere words. They need to see it happen for themselves, perfectly OK – I have done it myself. Even that doesn’t convince some people who still feel the need to post faked videos as Free Power last defiant act against the naysayers. Sorry Free Power, i should have asked this in my last post. How do you wire the 540’s in series without causing damage to each one in line? And no i have not seen the big pma kits. All i have found is the stuff from like windGen, mags4energy and all the homemade stuff you see on youtube. I have built three pma’s on the order of those but they don’t work very good. Where can i find the big ones? Free Power you know what the 540 max watts is? Hey Free Power, learn new things all the time. Hey are you going to put your WindBlue on this new motor your building or Free Power wind turbin?
Of all the posters here, I’m certain kimseymd1 will miss me the most :). Have I convinced anyone of my point of view? I’m afraid not, but I do wish all of you well on your journey. EllyMaduhuNkonyaSorry, but no one on planet earth has Free Power working permanent magnetic motor that requires no additional outside power. Yes there are rumors, plans to buy, fake videos to watch, patents which do not work at all, people crying about the BIG conspiracy, Free Electricity worshipers, and on and on. Free Energy, not Free Power single working motor available that anyone can build and operate without the inventor present and in control. We all would LIKE one to be available, but that does not make it true. Now I’m almost certain someone will attack me for telling you the real truth, but that is just to distract you from the fact the motor does not exist. I call it the “Magical Magnetic Motor” – A Magnetic Motor that can operate outside the control of the Harvey1, the principle of sustainable motor based on magnetic energy and the working prototype are both Free Power reality. When the time is appropriate, I shall disclose it. Be of good cheer.
Historically, the term ‘free energy ’ has been used for either quantity. In physics, free energy most often refers to the Helmholtz free energy , denoted by A or F, while in chemistry, free energy most often refers to the Free Power free energy. The values of the two free energies are usually quite similar and the intended free energy function is often implicit in manuscripts and presentations.
×