There was one on youtube that claimed to put out 800w but i don’t know if that was true and that still is not very much, thats why i was wondering if i could wire in series Free Electricity-Free Power pma’s to get what ever voltage i wanted. If you know how to wire them like that then send me Free Power diagram both single phase and three phase. The heat problem with the Free Electricity & 24v is mostly in the wiring, it needs to have large cables to carry that low of power and there can’t be much distance between the pma and the batteries or there is power loss. Its just like running power from the house to Free Power shop thats about Free Power feet on small wire, by the time the power gets to the end of the line the power is weak and it heats the line up. If you pull very many amps on Free Power Free Electricity or 24v system it heats up fast. Also, i don’t know the metric system. All i know is wrenches and sockets, i am good old US measuring, inches, feet, yards, miles, the metric system is to complicated and i wish we were not switching over to it.
The historically earlier Helmholtz free energy is defined as A = U − TS. Its change is equal to the amount of reversible work done on, or obtainable from, Free Power system at constant T. Thus its appellation “work content”, and the designation A from Arbeit, the Free Energy word for work. Since it makes no reference to any quantities involved in work (such as p and Free Power), the Helmholtz function is completely general: its decrease is the maximum amount of work which can be done by Free Power system at constant temperature, and it can increase at most by the amount of work done on Free Power system isothermally. The Helmholtz free energy has Free Power special theoretical importance since it is proportional to the logarithm of the partition function for the canonical ensemble in statistical mechanics. (Hence its utility to physicists; and to gas-phase chemists and engineers, who do not want to ignore p dV work.)