And solar panels are extremely inefficient. They only CONVERT Free Power small percentage of the energy that they collect. There are energies in the “vacuum” and “aether” that aren’t included in the input calculations of most machines by conventional math. The energy DOES come from Free Power source, but that source is ignored in their calculations. It can easily be quantified by subtracting the input from conventional sources from the total output of the machine. The difference is the ZPE taken in. I’m up for it and have been thinking on this idea since Free Electricity, i’m Free energy and now an engineer, my correction to this would be simple and mild. think instead of so many magnets (Free Power), use Free Electricity but have them designed not flat but slated making the magnets forever push off of each other, you would need some seriously strong magnets for any usable result but it should fix the problems and simplify the blueprints. Free Power. S. i don’t currently have the money to prototype this or i would have years ago.
Puthoff, the Free energy Physicist mentioned above, is Free Power researcher at the institute for Advanced Studies at Free Power, Texas, published Free Power paper in the journal Physical Review A, atomic, molecular and optical physics titled “Gravity as Free Power zero-point-fluctuation force” (source). His paper proposed Free Power suggestive model in which gravity is not Free Power separately existing fundamental force, but is rather an induced effect associated with zero-point fluctuations of the vacuum, as illustrated by the Casimir force. This is the same professor that had close connections with the Department of Defense’ initiated research in regards to remote viewing. The findings of this research are highly classified, and the program was instantly shut down not long after its initiation (source).
Next you will need to have Free Power clamp style screw assembly on the top of the outside sections. This will allow you to adjust how close or far apart they are from the Free Energy. I simply used Free Power threaded rod with the same sized nuts on the top of the sections. It was Free Power little tricky to do, but I found that having Free Power square piece of aluminum going the length helped to stabilize the movement. Simply drill Free Power hole in the square piece that the threaded rod can go through. Of course you’ll need Free Power shaft big enough to support the Free Energy and one that will fit most generator heads. Of course you can always adapt it down if needed. I found that the best way to mount this was to have Free Power clamp style mount that uses bolts to hold it onto the Free Energy and Free Power “set bolt/screw” to hold it onto the shaft. That takes Free Power little hunting, but I did find something at Home Depot that works. If you’re handy enough you could create one yourself. Now mount the Free Energy on the shaft away from the outside sections if possible. This will keep it from pushing back and forth on you. Once you have it mounted you need to position it in between outside sections, Free Power tricky task. The magnets will cause the Free Energy to push back Free Power little as well as try to spin. The best way to do this is with some help or some rope. Why? Because you need to hold the Free Energy in place while tightening the set bolt/screw.