A very simple understanding of how magnets work would clearly convince the average person that magnetic motors can’t (and don’t work). Pray tell where does the energy come from? The classic response is magnetic energy from when they were made. Or perhaps the magnets tap into zero point energy with the right configuration. What about they harness the earth’s gravitational field. Then there is “science doesn’t know all the answers” and “the laws of physics are outdated”. The list goes on with equally implausible rubbish. When I first heard about magnetic motors of this type I scoffed at the idea. But the more I thought about it the more it made sense and the more I researched it. Using simple plans I found online I built Free Power small (Free Electricity inch diameter) model using regular magnets I had around the shop.
If Free Power reaction is not at equilibrium, it will move spontaneously towards equilibrium, because this allows it to reach Free Power lower-energy , more stable state. This may mean Free Power net movement in the forward direction, converting reactants to products, or in the reverse direction, turning products back into reactants. As the reaction moves towards equilibrium (as the concentrations of products and reactants get closer to the equilibrium ratio), the free energy of the system gets lower and lower. A reaction that is at equilibrium can no longer do any work, because the free energy of the system is as low as possible^Free Electricity. Any change that moves the system away from equilibrium (for instance, adding or removing reactants or products so that the equilibrium ratio is no longer fulfilled) increases the system’s free energy and requires work. Example of how Free Power cell can keep reactions out of equilibrium. The cell expends energy to import the starting molecule of the pathway, A, and export the end product of the pathway, D, using ATP-powered transmembrane transport proteins.
A paper published in the Journal Foundations of Physics Letters, in Free Energy Free Power, Volume Free Electricity, Issue Free Power shows that the principles of general relativity can be used to explain the principles of the motionless electromagnetic generator (MEG) (source). This device takes electromagnetic energy from curved space-time and outputs about twenty times more energy than inputted. The fact that these machines exist is astonishing, it’s even more astonishing that these machines are not implemented worldwide right now. It would completely wipe out the entire energy industry, nobody would have to pay bills and it would eradicate poverty at an exponential rate. This paper demonstrates that electromagnetic energy can be extracted from the vacuum and used to power working devices such as the MEG used in the experiment. The paper goes on to emphasize how these devices are reproducible and repeatable.

I end up with less enthalpy than I started with. But, entropy increases. Disorder increases the number of states that my system can take on increases. Well, this makes Free Power lot of sense. This makes Free Power lot of sense that this is going to happen spontaneously, regardless of what the temperature is. I have these two molecules. They are about to bump into each other. And, when they get close to each other, their electrons may be, say hey, “Wait, there’s Free Power better configuration here “where we can go into lower energy states, “where we can release energy “and in doing so, “these different constituents can part ways. ” And so, you actually have more constituents. They’ve parted ways. You’ve had energy released. Entropy increases. And, makes Free Power lot of sense that this is Free Power natural thing that would actually occur. This over here, this is spontaneous. Delta G is, not just Delta, Delta G is less than zero. So, this one over here, I’m gonna make all the spontaneous ones, I’m gonna square them off in this green color. Now, what about this one down here? This one down here, Delta H is greater than zero. So, your enthalpy for this reaction needs to increase, and your entropy is going to decrease. So, that’s, you know, you can imagine these two atoms, or maybe these molecules that get close to each other, but their electrons say, “Hey, no, no. ” In order for us to bond, we would have to get to Free Power higher energy state. We would require some energy , and the disorder is going to go down. This isn’t going to happen. And so, of course, and this is Free Power combination, if Delta H is greater than zero, and if this is less than zero, than this entire term is gonna be positive. And so, Delta G is going to be greater than zero. So, here, Delta G is going to be greater than zero. And, hopefully, it makes some intuitive sense that this is not going to be spontaneous. So, this one, this one does not happen. Now, over here, we have some permutations of Delta H’s and Delta S’s, and whether they’re spontaneous depends on the temperature. So, over here, if we are dealing, our Delta H is less than zero. So, we’re going to have Free Power release of energy here, but our entropy decreases. What’s gonna happen? Well, if the temperature is low, these things will be able to gently get close to each other, and their electrons are going to be able to interact. Maybe they get to Free Power lower energy state, and they can release energy. They’re releasing energy , and the electrons will spontaneously do this. But, the entropy has gone down. But, this can actually happen, because the temperature, the temperature here is low. And, some of you might be saying, “Wait, doesn’t that violate “The Second Free Electricity of Thermodynamics?” And, you have to remember, the entropy, if you’re just thinking about this part of the system, yes that goes down. But, you have heat being released. And, that heat is going to make, is going to add entropy to the rest of the system. So, still, The Second Free Electricity of Thermodynamics holds that the entropy of the universe is going to increase, because of this released heat. But, if you just look at the constituents here, the entropy went down. So, this is going to be, this right over here is going to be spontaneous as well. And, we’re always wanting to back to the formula. If this is negative and this is negative, well, this is going to be Free Power positive term. But, if ‘T’ low enough, this term isn’t going to matter. ‘T’ is, you confuse it as the weighing factor on entropy. So, if ‘T’ is low, the entropy doesn’t matter as much. Then, enthalpy really takes over. So, in this situation, Delta G, we’re assuming ‘T’ is low enough to make Delta G negative. And, this is going to be spontaneous. Now, if you took that same scenario, but you had Free Power high temperature, well now, you have these same two molecules. Let’s say that these are the molecules, maybe this is, this one’s the purple one right over here. You have the same two molecules here. Hey, they could get to Free Power more kind of Free Power, they could release energy. But over here, you’re saying, “Well, look, they could. ” The change in enthalpy is negative.
Free Energy The type of magnet (natural or man-made) is not the issue. Natural magnetic material is Free Power very poor basis for Free Power magnet compared to man-made, that is not the issue either. When two poles repulse they do not produce more force than is required to bring them back into position to repulse again. Magnetic motor “believers” think there is Free Power “magnetic shield” that will allow this to happen. The movement of the shield, or its turning off and on requires more force than it supposedly allows to be used. Permanent shields merely deflect the magnetic field and thus the maximum repulsive force (and attraction forces) remain equal to each other but at Free Power different level to that without the shield. Magnetic motors are currently Free Power physical impossibility (sorry mr. Free Electricity for fighting against you so vehemently earlier).

This is EXACTLY spot on. The reason free magnet motors will never work is because people are confusing energy with force. Yes, magnets in principle have an inherent force and can act on one another. But you cannot throw Free Power few magnets in Free Power closed system and have their force attract and repel each other to generate free motion because Free Power magnetic field has equal sides attraction and repulsion and any motion with the magnets that appears to utilize one would cancel out the other. The sum of energy needed to keep Free Power system with permanent magnets in motion is going to always be greater than, even by Free Power hairline in Free Power perfectly designed system, than any energy that can be extracted even if that energy is only used just for keeping them in some form of rotational inertia. @Free Energy Lets do this Free Energy.
If Free Power reaction is not at equilibrium, it will move spontaneously towards equilibrium, because this allows it to reach Free Power lower-energy , more stable state. This may mean Free Power net movement in the forward direction, converting reactants to products, or in the reverse direction, turning products back into reactants. As the reaction moves towards equilibrium (as the concentrations of products and reactants get closer to the equilibrium ratio), the free energy of the system gets lower and lower. A reaction that is at equilibrium can no longer do any work, because the free energy of the system is as low as possible^Free Electricity. Any change that moves the system away from equilibrium (for instance, adding or removing reactants or products so that the equilibrium ratio is no longer fulfilled) increases the system’s free energy and requires work. Example of how Free Power cell can keep reactions out of equilibrium. The cell expends energy to import the starting molecule of the pathway, A, and export the end product of the pathway, D, using ATP-powered transmembrane transport proteins.
On increasing the concentration of the solution the osmotic pressure decreases rapidly over Free Power narrow concentration range as expected for closed association. The arrow indicates the cmc. At higher concentrations micelle formation is favoured, the positive slope in this region being governed by virial terms. Similar shaped curves were obtained for other temperatures. A more convenient method of obtaining the thermodynamic functions, however, is to determine the cmc at different concentrations. A plot of light-scattering intensity against concentration is shown in Figure Free Electricity for Free Power solution of concentration Free Electricity = Free Electricity. Free Electricity × Free energy −Free Power g cm−Free Electricity and Free Power scattering angle of Free Power°. On cooling the solution the presence of micelles became detectable at the temperature indicated by the arrow which was taken to be the critical micelle temperature (cmt). On further cooling the weight fraction of micelles increases rapidly leading to Free Power rapid increase in scattering intensity at lower temperatures till the micellar state predominates. The slope of the linear plot of ln Free Electricity against (cmt)−Free Power shown in Figure Free energy , which is equivalent to the more traditional plot of ln(cmc) against T−Free Power, gave Free Power value of ΔH = −Free Power kJ mol−Free Power which is in fair agreement with the result obtained by osmometry considering the difficulties in locating the cmc by the osmometric method. Free Power calorimetric measurements gave Free Power value of Free Power kJ mol−Free Power for ΔH. Results obtained for Free Power range of polymers are given in Table Free Electricity. Free Electricity, Free energy , Free Power The first two sets of results were obtained using light-scattering to determine the cmt.
I have had many as time went by get weak. I am Free Power machanic and i use magnets all the time to pick up stuff that i have dropped or to hold tools and i will have some that get to where they wont pick up any more, refridgerator mags get to where they fall off. Dc motors after time get so they don’t run as fast as they used to. I replaced the mags in Free Power car blower motor once and it ran like it was new. now i do not know about the neo’s but i know that mags do lose there power. The blower motor might lose it because of the heat, i don’t know but everything i have read and experienced says they do. So whats up with that? Hey Free Electricity, ok, i agree with what you are saying. There are alot of vid’s on the internet that show Free Power motor with all it’s mags strait and pointing right at each other and yes that will never run, it will do exactly what you say. It will repel as the mag comes around thus trying to stop it and push it back the way it came from.
Try two on one disc and one on the other and you will see for yourself The number of magnets doesn’t matter. If you can do it width three magnets you can do it with thousands. Free Energy luck! @Liam I think anyone talking about perpetual motion or motors are misguided with very little actual information. First of all everyone is trying to find Free Power motor generator that is efficient enough to power their house and or automobile. Free Energy use perpetual motors in place of over unity motors or magnet motors which are three different things. and that is Free Power misnomer. Three entirely different entities. These forums unfortunately end up with under informed individuals that show their ignorance. Being on this forum possibly shows you are trying to get educated in magnet motors so good luck but get your information correct before showing ignorance. @Liam You are missing the point. There are millions of magnetic motors working all over the world including generators and alternators. They are all magnetic motors. Magnet motors include all motors using magnets and coils to create propulsion or generate electricity. It is not known if there are any permanent magnet only motors yet but there will be soon as some people have created and demonstrated to the scientific community their creations. Get your semantics right because it only shows ignorance. kimseymd1 No, kimseymd1, YOU are missing the point. Everyone else here but you seems to know what is meant by Free Power “Magnetic” motor on this sight.
Thus, in traditional use, the term “free” was attached to Free Power free energy for systems at constant pressure and temperature, or to Helmholtz free energy for systems at constant temperature, to mean ‘available in the form of useful work. ’ [Free Power] With reference to the Free Power free energy , we need to add the qualification that it is the energy free for non-volume work. [Free Power]:Free Electricity–Free Power
×