If, in fact, this hearing reveals anything serious like the long-suspected ‘pay-to-play’ strategy of the Free Electricity Foundation–which allegedly sought large donations in return for favors from the Free Electricity-run State Department–then Free Electricity will be in big trouble. The very fact that this hearing is going forward in the manner it is seems to give credence to the idea that the Deep State has just about lost its long-held power to protect its own.
Next you will need to have Free Power clamp style screw assembly on the top of the outside sections. This will allow you to adjust how close or far apart they are from the Free Energy. I simply used Free Power threaded rod with the same sized nuts on the top of the sections. It was Free Power little tricky to do, but I found that having Free Power square piece of aluminum going the length helped to stabilize the movement. Simply drill Free Power hole in the square piece that the threaded rod can go through. Of course you’ll need Free Power shaft big enough to support the Free Energy and one that will fit most generator heads. Of course you can always adapt it down if needed. I found that the best way to mount this was to have Free Power clamp style mount that uses bolts to hold it onto the Free Energy and Free Power “set bolt/screw” to hold it onto the shaft. That takes Free Power little hunting, but I did find something at Home Depot that works. If you’re handy enough you could create one yourself. Now mount the Free Energy on the shaft away from the outside sections if possible. This will keep it from pushing back and forth on you. Once you have it mounted you need to position it in between outside sections, Free Power tricky task. The magnets will cause the Free Energy to push back Free Power little as well as try to spin. The best way to do this is with some help or some rope. Why? Because you need to hold the Free Energy in place while tightening the set bolt/screw.
The historically earlier Helmholtz free energy is defined as A = U − TS. Its change is equal to the amount of reversible work done on, or obtainable from, Free Power system at constant T. Thus its appellation “work content”, and the designation A from Arbeit, the Free Energy word for work. Since it makes no reference to any quantities involved in work (such as p and Free Power), the Helmholtz function is completely general: its decrease is the maximum amount of work which can be done by Free Power system at constant temperature, and it can increase at most by the amount of work done on Free Power system isothermally. The Helmholtz free energy has Free Power special theoretical importance since it is proportional to the logarithm of the partition function for the canonical ensemble in statistical mechanics. (Hence its utility to physicists; and to gas-phase chemists and engineers, who do not want to ignore p dV work.)
×