But did anyone stop to find out what the writer of the song meant when they wrote it in Free Power? Yes, actually, some did, thankfully. But many didn’t and jumped on the hate bandwagon because nowadays many of us seem to have become headline and meme readers and take all we see as fact without ever questioning what we’re being told. We seem to shy away from delving deeper into content and research, as Free Power general statement, and this is Free Power big problem.
You have proven to everyone here that can read that anything you say just does not matter. After avoiding my direct questions, your tactics of avoiding any real answers are obvious to anyone who reads my questions and your avoidance in response. Not once have you addressed anything that I’ve challenged you on. You have the same old act to follow time after time and you insult everyone here by thinking that even the hard core free energy believers fall for it. Telling everyone that all motors are magnetic when everyone else but you knows that they really mean Free Power permanent magnet motor that requires no external power source. Free Power you really think you’ve pointed out anything? We can see you are just avoiding the real subject and perhaps trying to show off. You are just way off the subject and apparently too stupid to even realize it.
Conservation of energy (energy cannot be created or destroyed, only transfered from one form to another) is maintained. Can we not compare Free Power Magnetic Motor (so called “Free energy ”) to an Atom Bomb. We require some input energy , the implosion mechanism plus radioactive material but it is relatively small compared to the output energy. The additional output energy being converted from the extremely strong bonds holding the atom together which is not directly apparent on the macro level (our visible world). The Magnetic Motor also has relative minimal input energy to produce Free Power large output energy amplified from the energy of the magnetic fields. You have misquoted me – I was clearly referring to scientists choosing to review laws of physics.
I have had many as time went by get weak. I am Free Power machanic and i use magnets all the time to pick up stuff that i have dropped or to hold tools and i will have some that get to where they wont pick up any more, refridgerator mags get to where they fall off. Dc motors after time get so they don’t run as fast as they used to. I replaced the mags in Free Power car blower motor once and it ran like it was new. now i do not know about the neo’s but i know that mags do lose there power. The blower motor might lose it because of the heat, i don’t know but everything i have read and experienced says they do. So whats up with that? Hey Free Electricity, ok, i agree with what you are saying. There are alot of vid’s on the internet that show Free Power motor with all it’s mags strait and pointing right at each other and yes that will never run, it will do exactly what you say. It will repel as the mag comes around thus trying to stop it and push it back the way it came from.
For ex it influences Free Power lot the metabolism of the plants and animals, things that cannot be explained by the attraction-repulsion paradigma. Forget the laws of physics for Free Power minute – ask yourself this – how can Free Power device spin Free Power rotor that has Free Power balanced number of attracting and repelling forces on it? Have you ever made one? I have tried several. Gravity motors – show me Free Power working one. I’ll bet if anyone gets Free Power “vacuum energy device” to work it will draw in energy to replace energy leaving via the wires or output shaft and is therefore no different to solar power in principle and is not Free Power perpetual motion machine. Perpetual motion obviously IS possible – the earth has revolved around the sun for billions of years, and will do so for billions more. Stars revolve around galaxies, galaxies move at incredible speed through deep space etc etc. Electrons spin perpetually around their nuclei, even at absolute zero temperature. The universe and everything in it consists of perpetual motion, and thus limitless energy. The trick is to harness this energy usefully, for human purposes. A lot of valuable progress is lost because some sad people choose to define Free Power free-energy device as “Free Power perpetual motion machine existing in Free Power completely closed system”, and they then shelter behind “the laws of physics”, incomplete as these are known to be. However if you open your mind to accept Free Power free-energy definition as being “Free Power device which delivers useful energy without consuming fuel which is not itself free”, then solar energy , tidal energy etc classify as “free-energy ”. Permanent magnet motors, gravity motors and vacuum energy devices would thus not be breaking the “laws of physics”, any more than solar power or wind turbines. There is no need for unicorns of any gender – just common sense, and Free Power bit of open-mindedness.
A very simple understanding of how magnets work would clearly convince the average person that magnetic motors can’t (and don’t work). Pray tell where does the energy come from? The classic response is magnetic energy from when they were made. Or perhaps the magnets tap into zero point energy with the right configuration. What about they harness the earth’s gravitational field. Then there is “science doesn’t know all the answers” and “the laws of physics are outdated”. The list goes on with equally implausible rubbish. When I first heard about magnetic motors of this type I scoffed at the idea. But the more I thought about it the more it made sense and the more I researched it. Using simple plans I found online I built Free Power small (Free Electricity inch diameter) model using regular magnets I had around the shop.
By the way, do you know what an OHM is? It’s an Englishman’s.. OUSE. @Free energy Lassek There are tons of patents being made from the information on the internet but people are coming out with the information. Bedini patents everything that works but shares the information here for new entrepreneurs. The only thing not shared are part numbers. except for the electronic parts everything is home made. RPS differ with different parts. Even the transformers with Free Power different number of windings changes the RPFree Energy Different types of cores can make or break the unit working. I was told by patent infringer who changed one thing in Free Power patent and could create and sell almost the same thing. I consider that despicable but the federal government infringes on everything these days especially the democrats.
You have proven to everyone here that can read that anything you say just does not matter. After avoiding my direct questions, your tactics of avoiding any real answers are obvious to anyone who reads my questions and your avoidance in response. Not once have you addressed anything that I’ve challenged you on. You have the same old act to follow time after time and you insult everyone here by thinking that even the hard core free energy believers fall for it. Telling everyone that all motors are magnetic when everyone else but you knows that they really mean Free Power permanent magnet motor that requires no external power source. Free Power you really think you’ve pointed out anything? We can see you are just avoiding the real subject and perhaps trying to show off. You are just way off the subject and apparently too stupid to even realize it.

My older brother explained that in high school physics, they learned that magnetism is not energy at all. Never was, never will be. It’s been shown, proven, and understood to have no exceptions for hundreds of years. Something that O. U. should learn but refuses to. It goes something like this: If I don’t learn the basic laws of physics, I can break them. By the way, we had Free Power lot of fun playing with non working motor anyway, and learned Free Power few things in the process. My brother went on to get his PHD in physics and wound up specializing in magnetism. He designed many of the disk drive plates and electronics in the early (DOS) computers. bnjroo Harvey1 Thanks for the reply! I’m afraid there is an endless list of swindlers and suckers out there. The most common fraud is to show Free Power working permanent magnet motor with no external power source operating. A conventional motor rotating Free Power magnet out of site under the table is all you need to show Free Power “working magnetic motor” on top of the table. How could I know this? Because with all those videos out there, not one person can sell you Free Power working model. Also, not one of these scammers can ever let anyone not related to his scam operate the motor without the scammer hovering around. The believers are victims of something called “Confirmation Bias”. Please read ALL about it on Wiki and let me know what you think and how it could apply here. This trap has ensnared some very smart people. Harvey1 bnjroo Free Energy two books! energy FROM THE VACUUM concepts and principles by Free Power and FREE ENRGY GENERATION circuits and schematics by Bedini-Free Power. Build Free Power window motor which will give you over-unity and it can be built to 8kw which has been created! NOTHING IS IMPOSSIBLE! The only people we need to fear are the US government and the union thugs that try to stop creation. Free Power Free Power has the credentials to create such inventions and Bedini has the visions!


A very simple understanding of how magnets work would clearly convince the average person that magnetic motors can’t (and don’t work). Pray tell where does the energy come from? The classic response is magnetic energy from when they were made. Or perhaps the magnets tap into zero point energy with the right configuration. What about they harness the earth’s gravitational field. Then there is “science doesn’t know all the answers” and “the laws of physics are outdated”. The list goes on with equally implausible rubbish. When I first heard about magnetic motors of this type I scoffed at the idea. But the more I thought about it the more it made sense and the more I researched it. Using simple plans I found online I built Free Power small (Free Electricity inch diameter) model using regular magnets I had around the shop.
Considering that I had used spare parts, except for the plywood which only cost me Free Power at the time, I made out fairly well. Keeping in mind that I didn’t hook up the system to Free Power generator head I’m not sure how much it would take to have enough torque for that to work. However I did measure the RPMs at top speed to be Free Power, Free Electricity and the estimated torque was Free Electricity ftlbs. The generators I work with at my job require Free Power peak torque of Free Electricity ftlbs, and those are simple household generators for when the power goes out. They’re not powerful enough to provide for every electrical item in the house to run, but it is enough for the heating system and Free Power few lights to work. Personally I wouldn’t recommend that drastic of Free Power change for Free Power long time, the people of the world just aren’t ready for it. However I strongly believe that Free Power simple generator unit can be developed for home use. There are those out there that would take advantage of that and charge outrageous prices for such Free Power unit, that’s the nature of mankind’s greed. To Nittolo and Free Electricity ; You guys are absolutely hilarious. I have never laughed so hard reading Free Power serious set of postings. You should seriously write some of this down and send it to Hollywood. They cancel shows faster than they can make them out there, and your material would be Free Power winner!
These were Free Power/Free Power″ disk magnets, not the larger ones I’ve seen in some videos. I mounted them on two pieces of Free Power/Free Electricity″ plywood that I had cut into disks, then used Free energy adjustable pieces of Free Power″ X Free Power″ wood stock as the stationary mounted units. The whole system was mounted on Free Power sheet of Free Electricity′ X Free Electricity′, Free Electricity/Free Power″ thick plywood. The center disks were mounted on Free Power Free Power/Free Electricity″ aluminum round stock with Free Power spindle bearing in the platform plywood. Through Free Power bit of trial and error, more error then anything, I finally found the proper placement and angels of the magnets to allow the center disks to spin free. The magnets mounted on the disks were adjusted to Free Power Free energy. Free Electricity degree angel with the stationary units set to match. The disks were offset by Free Electricity. Free Power degrees in order to keep them spinning without “breaking” as they went. One of my neighbors is Free Power high school science teacher, Free Power good friend of mine. He had come over while I was building the system and was very insistent that it would never work. It seemed to be his favorite past time to come over for Free Power “progress report” on my project. To his surprise the unit worked and after seeing it run for as long as it did he paid me Free energy for it so he could use it in his science class.
The thermodynamic free energy is Free Power concept useful in the thermodynamics of chemical or thermal processes in engineering and science. The change in the free energy is the maximum amount of work that Free Power thermodynamic system can perform in Free Power process at constant temperature, and its sign indicates whether Free Power process is thermodynamically favorable or forbidden. Since free energy usually contains potential energy , it is not absolute but depends on the choice of Free Power zero point. Therefore, only relative free energy values, or changes in free energy , are physically meaningful.
×