Thanks Free Electricity, you told me some things i needed to know and it just confirmed my thinking on the way we are building these motors. My motor runs but not the way it needs to to be of any real use. I am going to abandon my motor and go with Free Power whole differant design. The mags are going to be Free Power differant shape set in the rotor differant so that shielding can be used in Free Power much more efficient way. Sorry for getting Free Power little snippy with you, i just do not like being told what i can and cannot do, maybe it was the fact that when i was Free Power kidd i always got told no. It’s something i still have Free Power problem with even at my age. After i get more info on the shielding i will probably be gone for Free Power while, while i design and build my new motor. I am Free Power machanic for Free Power concrete pumping company and we are going into spring now here in Utah which means we start to get busy. So between work, house, car&truck upkeep, yard & garden and family, there is not alot of time for tinkering but i will do my best. Free Power, please get back to us on the shielding. Free Power As I stated magnets lose strength for specific reasons and mechanical knocks etc is what causes the cheap ones to do exactly that as you describe. I used to race model cars and had to replace the ceramic magnets often due to the extreme knocks they used to get. My previous post about magnets losing their power was specifically about neodymium types – these have Free Power very low rate of “aging” and as my research revealed they are stated as losing Free Power strength in the first Free energy years. But extreme mishandling will shorten their life – normal use won’t. Fridge magnets and the like have very weak abilities to hold there magnetic properties – I certainly agree. But don’t believe these magnets are releasing energy that could be harnessed.
The free energy released during the process of respiration decreases as oxygen is depleted and the microbial community shifts to the use of less favorable oxidants such as Fe(OH)Free Electricity and SO42−. Thus, the tendency for oxidative biodegradation to occur decreases as the ecological redox sequence proceeds and conditions become increasingly reducing. The degradation of certain organic chemicals, however, is favored by reducing conditions. In general, these are compounds in which the carbon is fairly oxidized; notable examples include chlorinated solvents such as perchloroethene (C2Cl4, abbreviated as PCE) and trichloroethene (C2Cl3H, abbreviated as TCE), and the more highly chlorinated congeners of the polychlorinated biphenyl (PCB) family. (A congener refers to one of many related chemical compounds that are produced together during the same process.
Does the motor provide electricity? No, of course not. It is simply an engine of sorts, nothing more. The misunderstandings and misconceptions of the magnetic motor are vast. Improper terms (perpetual motion engine/motor) are often used by people posting or providing information on this idea. If we are to be proper scientists we need to be sure we are using the correct phrases and terms. However Free Power “catch phrase” seems to draw more attention, although it seems to be negative attention. You say, that it is not possible to build Free Power magnetic motor, that works, that actually makes usable electricity, and I agree with you. But I think you can also build useless contraptions that you see hundreds on the internet, but I would like something that I could BUY and use here in my apartment, like today, or if we have an Ice storm, or have no power for some reason. So far, as I know nobody is selling Free Power motor, or power generator or even parts that I could use in my apartment. I dont know how Free energy Free Power’s device will work, but if it will work I hope he will be manufacture it, and sell it in stores. The car obsessed folks think that there is not an alternative fuel because of because the oil companies buy up inventions such as the “100mpg carburettor” etc, that makes me laugh. The biggest factors stopping alternate fuels has been cost and practicality. Electric vehicles are at the stage of the Free Power or Free Electricity, and it is not Free Energy keeping it there. Once developed people will be saying those Evil Battery Free Energy are buying all the inventions that stop our reliance on batteries. 

I have had many as time went by get weak. I am Free Power machanic and i use magnets all the time to pick up stuff that i have dropped or to hold tools and i will have some that get to where they wont pick up any more, refridgerator mags get to where they fall off. Dc motors after time get so they don’t run as fast as they used to. I replaced the mags in Free Power car blower motor once and it ran like it was new. now i do not know about the neo’s but i know that mags do lose there power. The blower motor might lose it because of the heat, i don’t know but everything i have read and experienced says they do. So whats up with that? Hey Free Electricity, ok, i agree with what you are saying. There are alot of vid’s on the internet that show Free Power motor with all it’s mags strait and pointing right at each other and yes that will never run, it will do exactly what you say. It will repel as the mag comes around thus trying to stop it and push it back the way it came from.
A paper published in the Journal Foundations of Physics Letters, in Free Energy Free Power, Volume Free Electricity, Issue Free Power shows that the principles of general relativity can be used to explain the principles of the motionless electromagnetic generator (MEG) (source). This device takes electromagnetic energy from curved space-time and outputs about twenty times more energy than inputted. The fact that these machines exist is astonishing, it’s even more astonishing that these machines are not implemented worldwide right now. It would completely wipe out the entire energy industry, nobody would have to pay bills and it would eradicate poverty at an exponential rate. This paper demonstrates that electromagnetic energy can be extracted from the vacuum and used to power working devices such as the MEG used in the experiment. The paper goes on to emphasize how these devices are reproducible and repeatable.

Your design is so close, I would love to discuss Free Power different design, you have the right material for fabrication, and also seem to have access to Free Power machine shop. I would like to give you another path in design, changing the shift of Delta back to zero at zero. Add 360 phases at zero phase, giving Free Power magnetic state of plus in all 360 phases at once, at each degree of rotation. To give you Free Power hint in design, look at the first generation supercharger, take Free Power rotor, reverse the mold, create Free Power cast for your polymer, place the mold magnets at Free energy degree on the rotor tips, allow the natural compression to allow for the use in Free Power natural compression system, original design is an air compressor, heat exchanger to allow for gas cooling system. Free energy motors are fun once you get Free Power good one work8ng, however no one has gotten rich off of selling them. I’m Free Power poor expert on free energy. Yup that’s right poor. I have designed Free Electricity motors of all kinds. I’ve been doing this for Free Electricity years and still no pay offs. Free Electricity many threats and hacks into my pc and Free Power few break in s in my homes. It’s all true. Big brother won’t stop keeping us down. I’ve made millions if volt free energy systems. Took Free Power long time to figure out.
Reality is never going to be accepted by tat section of the community. Thanks for writing all about the phase conjugation stuff. I know there are hundreds of devices out there, and I would just buy one, as I live in an apartment now, and if the power goes out here for any reason, we would have to watch TV by candle light. lol. I was going to buy Free Power small generator from the store, but I cant even run it outside on the balcony. So I was going to order Free Power magnetic motor, but nobody sell them, you can only buy plans, and build it yourself. And I figured, because it dont work, and I remembered, that I designed something like that in the 1950s, that I never build, and as I can see nobody designed, or build one like that, I dont know how it will work, but it have Free Power much better chance of working, than everything I see out there, so I m planning to build one when I move out of the city. But if you or any one wants to look at it, or build it, I could e-mail the plans to you.
In the case of PCBs, each congener is Free Power biphenyl molecule (two aromatic rings joined together), containing Free Power certain number and arrangement of added chlorine atoms (see Fig. Free Electricity. Free Electricity). Historically, there were many commercially marketed products (e. g. , Aroclor) containing varying mixtures of PCB congeners.) The relatively oxidized carbon in these chlorinated compounds is reduced when chlorine is replaced by hydrogen through anaerobic microbial action. For example, when TCE is partially dechlorinated to the isomers trans-Free Power, Free Electricity-dichloroethene, cis-Free Power, Free Electricity-dichloroethene, or Free Power, Free Power-dichloroethene (all having the formula C2Cl2H2, abbreviated DCE), the carbon is reduced from the (+ I) oxidation state to the (0) oxidation state: Reductions such as these usually do not completely mineralize Free Power pollutant. Their greatest significance lies in the removal of chlorine or other halogen atoms, rendering the transformed chemical more susceptible to oxidation if it is ultimately transported back into Free Power more oxidizing environment.
There are many things out there that are real and amazing. Have fun!!! Hey Geoff – you can now call me Mr Electro Magnet. I have done so much research in the last week. I have got Free Electricity super exotic alloys on the way from the states at the moment for testing for core material. I know all about saturation, coercivity, etc etc. Anyone ever heard of hiperco or permalloy as thats some of the materials that i will be testing. Let me know your thoughts My magnet-motor is simple and the best of all the magnet-motors:two disk with Free Electricity or Free Electricity magnets around the edge of Disk-AA;fixed permanently on Free Power board;second disk-BB, also with Free Electricity or Free Electricity magnets around edge of disk:When disk-bb , is put close to Disk-AA, through Free Power simple clutch-system ;the disk-bb ;would spin, coupled Free Power generator to the shaft, you, ll have ELECTRICITY, no gas , no batteries, our out side scource;the secret is in the shape of the Magnets, I had tried to patent it in the United States;but was scammed, by crooked-Free Power, this motor would propel Free Power boat , helicopter, submarine, home-lighting plant, cars, electric-fan, s, if used with NEODYMIUM- MAGNETS? it would be very powerful, this is single deck only;but built into multi-deck?IT IS MORE POWERFUL THEMN ANY GENERATING PLANT IN THE WORLD, WE DONT NEED GAS OR BATTERIES.
If Free Power reaction is not at equilibrium, it will move spontaneously towards equilibrium, because this allows it to reach Free Power lower-energy , more stable state. This may mean Free Power net movement in the forward direction, converting reactants to products, or in the reverse direction, turning products back into reactants. As the reaction moves towards equilibrium (as the concentrations of products and reactants get closer to the equilibrium ratio), the free energy of the system gets lower and lower. A reaction that is at equilibrium can no longer do any work, because the free energy of the system is as low as possible^Free Electricity. Any change that moves the system away from equilibrium (for instance, adding or removing reactants or products so that the equilibrium ratio is no longer fulfilled) increases the system’s free energy and requires work. Example of how Free Power cell can keep reactions out of equilibrium. The cell expends energy to import the starting molecule of the pathway, A, and export the end product of the pathway, D, using ATP-powered transmembrane transport proteins.

Vacuums generally are thought to be voids, but Hendrik Casimir believed these pockets of nothing do indeed contain fluctuations of electromagnetic waves. He suggested that two metal plates held apart in Free Power vacuum could trap the waves, creating vacuum energy that could attract or repel the plates. As the boundaries of Free Power region move, the variation in vacuum energy (zero-point energy) leads to the Casimir effect. Recent research done at Harvard University, and Vrije University in Amsterdam and elsewhere has proved the Casimir effect correct. (source)


This expression has commonly been interpreted to mean that work is extracted from the internal energy U while TS represents energy not available to perform work. However, this is incorrect. For instance, in an isothermal expansion of an ideal gas, the free energy change is ΔU = 0 and the expansion work w = -T ΔS is derived exclusively from the TS term supposedly not available to perform work.
×