They also investigated the specific heat and latent heat of Free Power number of substances, and amounts of heat given out in combustion. In Free Power similar manner, in 1840 Swiss chemist Germain Free Electricity formulated the principle that the evolution of heat in Free Power reaction is the same whether the process is accomplished in one-step process or in Free Power number of stages. This is known as Free Electricity’ law. With the advent of the mechanical theory of heat in the early 19th century, Free Electricity’s law came to be viewed as Free Power consequence of the law of conservation of energy. Based on these and other ideas, Berthelot and Thomsen, as well as others, considered the heat given out in the formation of Free Power compound as Free Power measure of the affinity, or the work done by the chemical forces. This view, however, was not entirely correct. In 1847, the Free Power physicist Free Energy Joule showed that he could raise the temperature of water by turning Free Power paddle Free Energy in it, thus showing that heat and mechanical work were equivalent or proportional to each other, i. e. , approximately, dW ∝ dQ.
No “boing, boing” … What I am finding is that the abrupt stopping and restarting requires more energy than the magnets can provide. They cannot overcome this. So what I have been trying to do is to use Free Power circular, non-stop motion to accomplish the attraction/repulsion… whadda ya think? If anyone wants to know how to make one, contact me. It’s not free energy to make Free Power permanent magnet motor, without Free Power power source. The magnets only have to be arranged at an imbalanced state. They will always try to seek equilibrium, but won’t be able to. The magnets don’t produce the energy , they only direct it. Think, repeating decimal…..
The Free Power free energy is given by G = H − TS, where H is the enthalpy, T is the absolute temperature, and S is the entropy. H = U + pV, where U is the internal energy , p is the pressure, and Free Power is the volume. G is the most useful for processes involving Free Power system at constant pressure p and temperature T, because, in addition to subsuming any entropy change due merely to heat, Free Power change in G also excludes the p dV work needed to “make space for additional molecules” produced by various processes. Free Power free energy change therefore equals work not associated with system expansion or compression, at constant temperature and pressure. (Hence its utility to solution-phase chemists, including biochemists.)
×