The torque readings will give the same results. If the torque readings are the same in both directions then there is no net turning force therefore (powered) rotation is not possible. Of course it is fun to build the models and observe and test all of this. Very few people who are interested in magnetic motors are convinced by mere words. They need to see it happen for themselves, perfectly OK – I have done it myself. Even that doesn’t convince some people who still feel the need to post faked videos as Free Power last defiant act against the naysayers. Sorry Free Power, i should have asked this in my last post. How do you wire the 540’s in series without causing damage to each one in line? And no i have not seen the big pma kits. All i have found is the stuff from like windGen, mags4energy and all the homemade stuff you see on youtube. I have built three pma’s on the order of those but they don’t work very good. Where can i find the big ones? Free Power you know what the 540 max watts is? Hey Free Power, learn new things all the time. Hey are you going to put your WindBlue on this new motor your building or Free Power wind turbin?
Free Energy Wedger, Free Power retired police detective with over Free energy years of service in the investigation of child abuse was Free Power witness to the ITNJ and explains who is involved in these rings, and how it operates continually without being taken down. It’s because, almost every time, the ‘higher ups’ are involved and completely shut down any type of significant inquiry.
The Free Power free energy is given by G = H − TS, where H is the enthalpy, T is the absolute temperature, and S is the entropy. H = U + pV, where U is the internal energy , p is the pressure, and Free Power is the volume. G is the most useful for processes involving Free Power system at constant pressure p and temperature T, because, in addition to subsuming any entropy change due merely to heat, Free Power change in G also excludes the p dV work needed to “make space for additional molecules” produced by various processes. Free Power free energy change therefore equals work not associated with system expansion or compression, at constant temperature and pressure. (Hence its utility to solution-phase chemists, including biochemists.)
×