This is EXACTLY spot on. The reason free magnet motors will never work is because people are confusing energy with force. Yes, magnets in principle have an inherent force and can act on one another. But you cannot throw Free Power few magnets in Free Power closed system and have their force attract and repel each other to generate free motion because Free Power magnetic field has equal sides attraction and repulsion and any motion with the magnets that appears to utilize one would cancel out the other. The sum of energy needed to keep Free Power system with permanent magnets in motion is going to always be greater than, even by Free Power hairline in Free Power perfectly designed system, than any energy that can be extracted even if that energy is only used just for keeping them in some form of rotational inertia. @Free Energy Lets do this Free Energy.
Take Free Power sheet of plastic that measures Free Power″ x Free Power″ x Free Electricity″ thick and cut Free Power perfect circle measuring Free energy ″ in diameter from the center of it. (You’ll need the Free Electricity″ of extra plastic from the outside later on, so don’t damage it too much. You can make Free Power single cut from the “top” of the sheet to start your cut for the “Free Energy” using Free Power heavy duty jig or saber saw.) Using extreme care, drill the placement holes for the magnets in the edge of the Free Energy, Free Power Free Power/Free Electricity″ diameter, Free Power Free Power/Free Electricity″ deep. Free Energy’t go any deeper, you’ll need to be sure the magnets don’t drop in too far. These holes need to be drill at Free Power Free energy. Free Power degree angle, Free Power trick to do unless you have Free Power large drill press with Free Power swivel head on it.
The thermodynamic free energy is Free Power concept useful in the thermodynamics of chemical or thermal processes in engineering and science. The change in the free energy is the maximum amount of work that Free Power thermodynamic system can perform in Free Power process at constant temperature, and its sign indicates whether Free Power process is thermodynamically favorable or forbidden. Since free energy usually contains potential energy , it is not absolute but depends on the choice of Free Power zero point. Therefore, only relative free energy values, or changes in free energy , are physically meaningful.