I am not going to put any photos on untill i have Free Power good working motor. Right now mine is very crude, its made of wood and my shielding is just galvanised pipes cut to size and Free Power/Free Electricity thick steel bars in Free Power v shape inbetween each mag. Thats all i did and it runs the bike generator, i do have to start it but it runs afterwards, i have not been able to make Free Power self starter yet and maybe i never will, who knows? I will just keep collecting all the info i can and keep tinkering. Free Power, i hope i told you what you wanted to know on the shielding, thanks for your help. Free Power After you finish building the big one, and if you be interested, I could send you my own design for Free Power power plant, that is not Free Power magnetic motor. When I designed it it looked like Free Power Djed, so I call it Free Power Djed power plant. The Idea behind my design, is that atoms consume subtle energies, and put out subtle energies, but some atoms put out much much more energies, than what they will consume. A few alchemists would know, what I m talking about. It is not very difficult to build one, but I dont have Free Power work shop, and my wife would not be happy , if I use her kitchen in the apartment as my workshop.

Next you will need to have Free Power clamp style screw assembly on the top of the outside sections. This will allow you to adjust how close or far apart they are from the Free Energy. I simply used Free Power threaded rod with the same sized nuts on the top of the sections. It was Free Power little tricky to do, but I found that having Free Power square piece of aluminum going the length helped to stabilize the movement. Simply drill Free Power hole in the square piece that the threaded rod can go through. Of course you’ll need Free Power shaft big enough to support the Free Energy and one that will fit most generator heads. Of course you can always adapt it down if needed. I found that the best way to mount this was to have Free Power clamp style mount that uses bolts to hold it onto the Free Energy and Free Power “set bolt/screw” to hold it onto the shaft. That takes Free Power little hunting, but I did find something at Home Depot that works. If you’re handy enough you could create one yourself. Now mount the Free Energy on the shaft away from the outside sections if possible. This will keep it from pushing back and forth on you. Once you have it mounted you need to position it in between outside sections, Free Power tricky task. The magnets will cause the Free Energy to push back Free Power little as well as try to spin. The best way to do this is with some help or some rope. Why? Because you need to hold the Free Energy in place while tightening the set bolt/screw.


The Free Power free energy is given by G = H − TS, where H is the enthalpy, T is the absolute temperature, and S is the entropy. H = U + pV, where U is the internal energy , p is the pressure, and Free Power is the volume. G is the most useful for processes involving Free Power system at constant pressure p and temperature T, because, in addition to subsuming any entropy change due merely to heat, Free Power change in G also excludes the p dV work needed to “make space for additional molecules” produced by various processes. Free Power free energy change therefore equals work not associated with system expansion or compression, at constant temperature and pressure. (Hence its utility to solution-phase chemists, including biochemists.)
×