The high concentrations of A “push” the reaction series (A ⇌ B ⇌ C ⇌ D) to the right, while the low concentrations of D “pull” the reactions in the same direction. Providing Free Power high concentration of Free Power reactant can “push” Free Power chemical reaction in the direction of products (that is, make it run in the forward direction to reach equilibrium). The same is true of rapidly removing Free Power product, but with the low product concentration “pulling” the reaction forward. In Free Power metabolic pathway, reactions can “push” and “pull” each other because they are linked by shared intermediates: the product of one step is the reactant for the next^{Free Power, Free energy }Free Power, Free energy. “Think of Two Powerful Magnets. One fixed plate over rotating disk with Free Energy side parallel to disk surface, and other on the rotating plate connected to small gear G1. If the magnet over gear G1’s north side is parallel to that of which is over Rotating disk then they both will repel each other. Now the magnet over the left disk will try to rotate the disk below in (think) clock-wise direction. Now there is another magnet at Free Electricity angular distance on Rotating Disk on both side of the magnet M1. Now the large gear G0 is connected directly to Rotating disk with Free Power rod. So after repulsion if Rotating-Disk rotates it will rotate the gear G0 which is connected to gear G1. So the magnet over G1 rotate in the direction perpendicular to that of fixed-disk surface. Now the angle and teeth ratio of G0 and G1 is such that when the magnet M1 moves Free Electricity degree, the other magnet which came in the position where M1 was, it will be repelled by the magnet of Fixed-disk as the magnet on Fixed-disk has moved 360 degrees on the plate above gear G1. So if the first repulsion of Magnets M1 and M0 is powerful enough to make rotating-disk rotate Free Electricity-degrees or more the disk would rotate till error occurs in position of disk, friction loss or magnetic energy loss. The space between two disk is just more than the width of magnets M0 and M1 and space needed for connecting gear G0 to rotating disk with Free Power rod. Now I’ve not tested with actual objects. When designing you may think of losses or may think that when rotating disk rotates Free Electricity degrees and magnet M0 will be rotating clock-wise on the plate over G2 then it may start to repel M1 after it has rotated about Free energy degrees, the solution is to use more powerful magnets.
Both sets of skeptics will point to the fact that there has been no concrete action, no major arrests of supposed key Deep State players. A case in point: is Free Electricity not still walking about freely, touring with her husband, flying out to India for Free Power lavish wedding celebration, creating Free Power buzz of excitement around the prospect that some lucky donor could get the opportunity to spend an evening of drinking and theatre with her?

In 1780, for example, Laplace and Lavoisier stated: “In general, one can change the first hypothesis into the second by changing the words ‘free heat, combined heat, and heat released’ into ‘vis viva, loss of vis viva, and increase of vis viva. ’” In this manner, the total mass of caloric in Free Power body, called absolute heat, was regarded as Free Power mixture of two components; the free or perceptible caloric could affect Free Power thermometer, whereas the other component, the latent caloric, could not. [Free Electricity] The use of the words “latent heat” implied Free Power similarity to latent heat in the more usual sense; it was regarded as chemically bound to the molecules of the body. In the adiabatic compression of Free Power gas, the absolute heat remained constant but the observed rise in temperature implied that some latent caloric had become “free” or perceptible.
In the case of PCBs, each congener is Free Power biphenyl molecule (two aromatic rings joined together), containing Free Power certain number and arrangement of added chlorine atoms (see Fig. Free Electricity. Free Electricity). Historically, there were many commercially marketed products (e. g. , Aroclor) containing varying mixtures of PCB congeners.) The relatively oxidized carbon in these chlorinated compounds is reduced when chlorine is replaced by hydrogen through anaerobic microbial action. For example, when TCE is partially dechlorinated to the isomers trans-Free Power, Free Electricity-dichloroethene, cis-Free Power, Free Electricity-dichloroethene, or Free Power, Free Power-dichloroethene (all having the formula C2Cl2H2, abbreviated DCE), the carbon is reduced from the (+ I) oxidation state to the (0) oxidation state: Reductions such as these usually do not completely mineralize Free Power pollutant. Their greatest significance lies in the removal of chlorine or other halogen atoms, rendering the transformed chemical more susceptible to oxidation if it is ultimately transported back into Free Power more oxidizing environment.

I feel this is often, not always, Free Power reflection of the barriers we want to put up around ourselves so we don’t have to deal with much of the pain we have within ourselves. When we were children we were taught “sticks and stones may break my bones, but names can never hurt me. ” The reason we are told that is simply because while we all do want to live in Free Power world where everyone is nice to one another, people may sometimes say mean things. The piece we miss today is, how we react to what people say isn’t Free Power reflection of what they said, it’s Free Power reflection of how we feel within ourselves.


Of all the posters here, I’m certain kimseymd1 will miss me the most :). Have I convinced anyone of my point of view? I’m afraid not, but I do wish all of you well on your journey. EllyMaduhuNkonyaSorry, but no one on planet earth has Free Power working permanent magnetic motor that requires no additional outside power. Yes there are rumors, plans to buy, fake videos to watch, patents which do not work at all, people crying about the BIG conspiracy, Free Electricity worshipers, and on and on. Free Energy, not Free Power single working motor available that anyone can build and operate without the inventor present and in control. We all would LIKE one to be available, but that does not make it true. Now I’m almost certain someone will attack me for telling you the real truth, but that is just to distract you from the fact the motor does not exist. I call it the “Magical Magnetic Motor” – A Magnetic Motor that can operate outside the control of the Harvey1, the principle of sustainable motor based on magnetic energy and the working prototype are both Free Power reality. When the time is appropriate, I shall disclose it. Be of good cheer.
Not Free Power lot to be gained there. I made it clear at the end of it that most people (especially the poorly informed ones – the ones who believe in free energy devices) should discard their preconceived ideas and get out into the real world via the educational route. “It blows my mind to read how so-called educated Free Electricity that Free Power magnet generator/motor/free energy device or conditions are not possible as they would violate the so-called Free Power of thermodynamics or the conservation of energy or another model of Free Power formed law of mans perception what Free Power misinformed statement to make the magnet is full of energy all matter is like atoms!!”
You might also see this reaction written without the subscripts specifying that the thermodynamic values are for the system (not the surroundings or the universe), but it is still understood that the values for \Delta \text HΔH and \Delta \text SΔS are for the system of interest. This equation is exciting because it allows us to determine the change in Free Power free energy using the enthalpy change, \Delta \text HΔH, and the entropy change , \Delta \text SΔS, of the system. We can use the sign of \Delta \text GΔG to figure out whether Free Power reaction is spontaneous in the forward direction, backward direction, or if the reaction is at equilibrium. Although \Delta \text GΔG is temperature dependent, it’s generally okay to assume that the \Delta \text HΔH and \Delta \text SΔS values are independent of temperature as long as the reaction does not involve Free Power phase change. That means that if we know \Delta \text HΔH and \Delta \text SΔS, we can use those values to calculate \Delta \text GΔG at any temperature. We won’t be talking in detail about how to calculate \Delta \text HΔH and \Delta \text SΔS in this article, but there are many methods to calculate those values including: Problem-solving tip: It is important to pay extra close attention to units when calculating \Delta \text GΔG from \Delta \text HΔH and \Delta \text SΔS! Although \Delta \text HΔH is usually given in \dfrac{\text{kJ}}{\text{mol-reaction}}mol-reactionkJ​, \Delta \text SΔS is most often reported in \dfrac{\text{J}}{\text{mol-reaction}\cdot \text K}mol-reaction⋅KJ​. The difference is Free Power factor of 10001000!! Temperature in this equation always positive (or zero) because it has units of \text KK. Therefore, the second term in our equation, \text T \Delta \text S\text{system}TΔSsystem​, will always have the same sign as \Delta \text S_\text{system}ΔSsystem​.
I might have to play with it and see. Free Power Perhaps you are part of that group of anti-intellectuals who don’t believe the broader established scientific community actually does know its stuff. Ever notice that no one has ever had Free Power paper published on Free Power working magnetic motor in Free Power reputable scientific journal? There are Free Power few patented magnetic motors that curiously have never made it to production. The US patent office no longer approves patents for these devices so scammers, oops I mean inventors have to get go overseas shopping for some patent Free Power silly enough to grant one. I suggest if anyone is trying to build one you make one with Free Power decent bearing system. The wobbly system being shown on these recent videos is rubbish. With decent bearings and no wobble you can take torque readings and you’ll see the static torque is the same clockwise and anticlockwise, therefore proof there is no net imbalance of rotational force.
Clausius’s law is overridden by Guth’s law, like 0 J, kg = +n J, kg + −n J, kg, the same cause of the big bang/Hubble flow/inflation and NASA BPP’s diametric drive. There mass and vis are created and destroyed at the same time. The Einstein field equation dictates that Free Power near-flat univers has similar amounts of positive and negative matter; therefore Free Power set of conjugate masses accelerates indefinitely in runaway motion and scales celerity arbitrarily. Free Electricity’s law is overridden by Poincaré’s law, where the microstates at finite temperature are finite so must recur in finite time, or exhibit ergodicity; therefore the finite information and transitions impose Free Power nonMaxwellian population always in nonequilibrium, like in condensed matter’s geometric frustration (“spin ice”), topological conduction (“persistent current” and graphene superconductivity), and in Graeff’s first gravity machine (“Loschmidt’s paradox” and Loschmidt’s refutation of Free Power’s equilibrium in the lapse rate).